Microbiology Result: 1 working day

Clostridium difficile toxins A and B

This test detects Clostridium difficile toxins A and B in a stool sample. It is used to diagnose Clostridium difficile infection, which can cause severe damage to the bowel, especially after treatment with certain antibiotics.

Test code C2085 Preparing for laboratory tests

Some laboratory tests require specific preparation by the patient, concerning diet before sampling and the time of day at which to come to the laboratory for sampling. The patient can be informed about this by their doctor or by the staff of Sante Laboratorije. Many other tests, however, need no prior preparation, and samples do not have to be collected at a particular time or in relation to meals.

For information, contact us on +381 11 27 62 199 | +381 64 65 87 607 or in writing at office@clinica-sante.rs.

Preparation and sampling

Preparation
Guide to preparing for tests
Results available in
1 working day
Where it is done
All laboratories and map

Description

About the test

Clostridium difficile (now also called Clostridioides difficile) is a spore-forming bacterium that can be found in the gut even in people without any symptoms. When antibiotics upset the balance of the normal gut flora, this bacterium can multiply excessively and start producing toxins A and B. The toxins damage the lining of the large bowel and cause diarrhoea and, in more severe cases, serious inflammation of the colon (pseudomembranous colitis).

The Clostridium difficile Toxin A and B test detects toxins A and B in a stool sample, the substances with which the bacterium damages the bowel and causes disease. The result is interpreted together with the symptoms and helps to establish the diagnosis of Clostridium difficile infection.

The infection most often develops during or after antibiotic treatment and is more common in older people, in patients who have recently been in hospital, in people with weakened immunity and in people with chronic bowel disease. The test is done only in people who have diarrhoea and is not used to check whether treatment has worked, because the toxins can remain positive after recovery.

When it is recommended

  • Diarrhoea (three or more loose or watery stools in 24 hours) during antibiotic treatment or up to about three months afterwards;
  • Diarrhoea that starts during a hospital stay or shortly after discharge;
  • Diarrhoea with abdominal pain, fever or mucus in the stool, especially in older people, in people with weakened immunity or in people taking medicines that reduce stomach acid;
  • Suspected return of the infection (relapse) after completed treatment;
  • A flare-up of chronic inflammatory bowel disease (Crohn’s disease, ulcerative colitis), to rule out Clostridium difficile infection.

In babies under one year of age the test is generally not done, because carrying the bacterium without disease is common at that age.

Preparation

  • Collect the stool sample before starting treatment for the infection and before using suppositories.
  • Only loose or watery stool, which takes the shape of the container, is suitable for this test; formed stool is generally not tested.
  • Do not take laxatives for at least 48 hours before collecting the sample, as they can cause diarrhoea themselves.
  • Use a sterile container with a small spoon attached to the inside of the lid, and do not collect more than 4–5 spoonfuls of stool. The sample must not be mixed with urine or toilet water.
  • Bring the sample to the laboratory immediately after collection, or ask the laboratory how long the sample remains stable; until then, keep it in a cool place.

Sample

Fresh stool (loose or watery) in a sterile stool container.

Reference values

  • Negative – toxins A and B were not detected.
  • Positive – toxin A and/or toxin B was detected.

Reference values depend on the method and the laboratory; the values printed on your report apply to your result.

Interpreting the results

Negative result – no toxins were detected, so Clostridium difficile infection is less likely. A negative result does not rule out the infection completely, however, because the amount of toxin may be below the detection limit of the test; if symptoms persist, your doctor may recommend a PCR test for the toxin genes.

Positive result – Clostridium difficile toxins are present in the stool; together with matching symptoms, this supports a diagnosis of Clostridium difficile infection.

A positive result in someone without diarrhoea does not necessarily mean disease, because the bacterium can be present without causing symptoms.

Your doctor interprets the result together with your symptoms and other findings.

What can affect the result

  • Formed stool, or a sample mixed with urine or water;
  • Late delivery and storage at room temperature, because the toxins break down over time (possible false negative result);
  • Treatment with medicines active against Clostridium difficile started before the sample was collected;
  • Use of laxatives;
  • Carriage of the bacterium without disease, especially in young children;
  • A small amount of toxin in the sample.

Related tests

  • Clostridium difficile PCR – detects the toxin genes and helps when no toxins are detected but symptoms persist;
  • Stool culture – for other bacterial causes of diarrhoea;
  • Campylobacter antigen and Giardia antigen in stool – for other infectious causes of diarrhoea;
  • Faecal calprotectin – a marker of bowel inflammation;
  • Full blood count and C-reactive protein (CRP) – to assess the inflammatory response;
  • Creatinine and electrolytes – to assess fluid loss and the severity of the illness.

Part of a package

SanBiome Extended SanBiome - microbiome analysis + Zonulin (stool) + Calprotectin and 8 more 65.000 RSD instead of 70.132 RSD separately

How to order tests online?

Add the tests you want to your cart

Choose the tests you need and add them to your cart. Use the site search to find the tests you want more easily.

Pay online or at the laboratory

Payment method:

  • Online – payment uses 3D-Secure, a secure authentication protocol that minimises the risk of fraud.
  • At the laboratory – order your tests online and pay for them when you come to the laboratory.
Have your samples taken at one of our laboratories

After payment, you will receive an email confirming your order, with details of how to prepare for sampling. From then on, you can go to the Sante laboratory you chose when ordering your tests and have your samples taken.

Learn more
Back to top