Biochemistry Sample: blood Result: 1 working day

Procalcitonin (PCT)

Procalcitonin (PCT) is a biomarker used to assess and monitor bacterial infections and sepsis, and it helps to guide treatment. Raised levels usually indicate severe bacterial infections, such as pneumonia or meningitis, and PCT also helps to distinguish bacterial from viral infections.

Test code CS00855 Preparing for laboratory tests

Some laboratory tests require specific preparation by the patient, concerning diet before sampling and the time of day at which to come to the laboratory for sampling. The patient can be informed about this by their doctor or by the staff of Sante Laboratorije. Many other tests, however, need no prior preparation, and samples do not have to be collected at a particular time or in relation to meals.

For information, contact us on +381 11 27 62 199 | +381 64 65 87 607 or in writing at office@clinica-sante.rs.

Preparation and sampling

Preparation
Guide to preparing for tests
Sample
Blood
Results available in
1 working day
Where it is done
All laboratories and map

Description

About the test

Procalcitonin (PCT) is the precursor of the hormone calcitonin. In healthy people it is produced mainly by the C cells of the thyroid gland, and its concentration in the blood is very low.

In bacterial infections, under the influence of bacterial toxins and inflammatory mediators, many tissues throughout the body start to produce PCT, so its level rises quickly: an increase can be seen 3–6 hours after the infection begins, and the highest values are reached after 12–24 hours. In viral infections the rise is usually small, because the body’s response to viruses suppresses its production.

For this reason PCT helps to distinguish bacterial from viral infections, to assess the severity of an infection and the risk of sepsis, and to monitor the response to treatment: when treatment works, levels fall. PCT can help the doctor decide whether to start or stop antibiotic treatment.

PCT does not show where the infection is or which bacterium is causing it, and in localised infections, such as an abscess, levels may be normal.

When it is recommended

Important: if you have signs of a severe infection – high fever with chills, rapid or difficult breathing, confusion, extreme weakness or low blood pressure – contact a doctor or emergency services immediately and do not wait for a test result.

As recommended by the doctor, the test is done:

  • when a bacterial infection is suspected in a patient with fever and a decision is needed on whether antibiotics are required;
  • to distinguish bacterial from viral lower respiratory tract infections (for example pneumonia or acute bronchitis);
  • to assess the severity of an infection and the risk of sepsis;
  • to monitor the response to antibiotic treatment and decide how long it should last;
  • when bacterial meningitis is suspected, to distinguish it from viral meningitis;
  • to monitor patients after operations, severe injuries or burns, for early recognition of a bacterial infection.

Preparation

  • The test itself needs no special preparation or fasting. Like other urgent tests (such as C-reactive protein), it can be done at any time of day, as instructed by the doctor.
  • Tell your doctor about any antibiotic treatment you are receiving and about recent operations, injuries or burns.
  • If the test is not urgent and is done together with other blood tests, follow the general laboratory rules: blood is taken in the morning, between 7 and 10 a.m., after 12 hours of fasting (you may drink water as usual); if you take medicines, blood is taken before your morning dose, unless your doctor advises otherwise; do not take vitamin supplements the day before, and avoid strenuous physical exercise for 2 days beforehand.

Sample

Venous blood.

Reference values

In healthy people PCT levels are usually below 0.05 ng/mL.

The following approximate thresholds are used in clinical practice:

Assessment of systemic infection (sepsis):

  • below 0.5 ng/mL – low risk of sepsis; a localised infection is possible;
  • 0.5–2 ng/mL – systemic infection is possible;
  • 2–10 ng/mL – systemic infection (sepsis) is likely;
  • above 10 ng/mL – high risk of severe sepsis and septic shock.

Lower respiratory tract infections:

  • below 0.1 ng/mL – bacterial infection very unlikely;
  • 0.1–0.25 ng/mL – bacterial infection unlikely;
  • 0.25–0.5 ng/mL – bacterial infection possible;
  • above 0.5 ng/mL – bacterial infection likely.

Reference values depend on the method and the laboratory; the values printed on your report apply to your result.

Interpreting the results

Raised levels most often indicate a bacterial infection with a systemic response, such as sepsis, pneumonia, meningitis or a kidney infection; the higher the value, the more severe the infection usually is. A fall in values on repeated measurements suggests that treatment is working, while a further rise may point to treatment failure or a complication.

PCT can also be raised without a bacterial infection, for example:

  • after major surgery, severe injuries or burns;
  • in cardiogenic shock, severe inflammation of the pancreas (pancreatitis) or heat stroke;
  • in newborns during the first days of life (physiologically);
  • in severe kidney failure and during dialysis;
  • in some cancers, such as medullary thyroid cancer and small-cell lung cancer;
  • in some fungal infections and malaria.

Low levels are found in viral infections, in localised bacterial infections (for example an abscess), in infections with some atypical bacteria (for example Mycoplasma pneumoniae) and in the very early phase of an infection, when your doctor may recommend repeating the test after 6–24 hours.

Your doctor interprets the result together with your symptoms and other findings.

What can affect the result

  • The timing of the sample in relation to the start of the infection (PCT starts to rise after a few hours);
  • Antibiotic treatment started before the blood test;
  • Reduced kidney function;
  • Recent operations, injuries or burns;
  • The first days of life in newborns;
  • Differences between laboratory methods.

Related tests

  • C-reactive protein (CRP) – a general marker of inflammation;
  • Full blood count with differential – to assess the body’s response to infection;
  • Blood culture – to detect bacteria in the blood and guide the choice of antibiotic;
  • Urine culture – when a urinary tract infection is suspected;
  • Erythrocyte sedimentation rate (ESR) – a marker of inflammation;
  • Lactate – to assess the severity of sepsis;
  • Creatinine – to assess kidney function.

How to order tests online?

Add the tests you want to your cart

Choose the tests you need and add them to your cart. Use the site search to find the tests you want more easily.

Pay online or at the laboratory

Payment method:

  • Online – payment uses 3D-Secure, a secure authentication protocol that minimises the risk of fraud.
  • At the laboratory – order your tests online and pay for them when you come to the laboratory.
Have your samples taken at one of our laboratories

After payment, you will receive an email confirming your order, with details of how to prepare for sampling. From then on, you can go to the Sante laboratory you chose when ordering your tests and have your samples taken.

Learn more
Back to top